Detailing

The first detail is the legs, use your saw to bore a hole as indicated

4 cuts will complete the legs.

Make a cut along the face as shown, I am doing this because my eagle will be
sitting on a rock when completed.

The completed shape ready for the angle grinder

Completed base that should look like a rock when we are done

We will use the grinder to remove this area, use 16 or 50 grit wheel.

Follow the line you drew earlier with your grinder.

Grind from both sides and meet in the middle.

Begin smoothing sides, use light pressure with grinder.

Round out the wings carefully.

Tail must be be smoothed out as well.

Round the tail out and soothe the surfaces.

Trailing edge of wings should be sharp, once you have done all the smoothing
switch to the Dremel tool

Click to continue

Click here to return to the table of contents